7. Press â–² or â–¼ to select Auto Adjust, and then press the OK button.
After the environment measurements and paper are confirmed, and color calibration is executed, the adjustment val-
ue is set automatically.
Note
• A confirmation message may be displayed depending on the paper type.
Although you attempted to execute common calibration, since the pa-
per type differs from that executed the previous time, replace it with
the same paper type for which calibration was executed the previous
time.
Press â–² or â–¼ to select Stop, and then press the OK button.
This is displayed in the case of unique calibration.
To continue color calibration, press â–² or â–¼ to select Continue, and
then press the OK button.
• The application of the adjustment value when printing can be set in the printer driver or on the menu
of the Control Panel.
However, when the setting value of the printer driver and the setting value of the Control Panel differ,
the setting of the printer driver is prioritized.
Configure on the printer driver
menu. (Windows)
Configure Calibration Value.
(See "Paper Detailed Settings Dialog Box (Windows).")
→P.220
Configure on the printer driver
menu. (Mac OS X)
Configure Calibration Value.
(See "Paper Detailed Settings Dialog Box (Mac OS X).")
→P.500
Configure on the menu of the
Control Panel.
From Set./Adj. Menu, select Adjust Printer > Calibration
> Use Adj. Value.
(See "Menu Settings.") →P.914
• After executing color calibration, you can also adjust colors as desired in the printer driver. (See
"Adjusting the Color in the Printer Driver.") →P.55
Specifying Execution Guide
Execution Guide is a function in which a guide is displayed on the Control Panel, imagePROGRAF Status Monitor (Win-
dows), imagePROGRAF Printmonitor (Macintosh), or RemoteUI when you execute color calibration.
If you enable this function, an Execution Guide is displayed in the following cases.
• When a new Printhead has been installed
• When a certain amount of printing has been executed after color calibration is executed
• When the data of color calibration has been initialized
To enable the function, set "Set Exec. Guide" to On on the menu of the Control Panel.
(See "Menu Settings.") →P.914
Adjustments for Better Print Quality
>
Color adjustment
>
iPF6300S Using Color Calibration for Color Adjustment
7
847
To Next Page
Loading...
Need help?
General