3. If a password has been set on the printer, enter the password.
4. Click Network in the Device Manager menu at left to display the Network page.
5. Click Edit in the upper-right corner of the AppleTalk group to display the Edit AppleTalk Protocol Settings page.
6. Refer to the AppleTalk Settings Items table to complete the settings.
AppleTalk Settings Items
Item Details Default Setting
Phase
Type
Specify whether to use AppleTalk.
If you will use AppleTalk, choose Phase 2.
If you will not use AppleTalk, choose Disabled.
Disabled
Name
(*1)
Specify the object name used by AppleTalk (in up to 31 single-byte or 15 double-
byte characters).
However, do not use the following single-byte characters: @, *, :, and =.
Canon
NB-18GB
(xxxxxx)
Zone (*2) Specify the printer zone name, up to 31 single-byte characters.
However, do not use the following single-byte characters: Also avoid using * (which
represents the default zone) in the middle of a string.
*
*1: The object name you have specified in Name is displayed in Printer Setup Utility (or Print Center ) in Mac
OS X 10.2.8–10.4. If you use multiple printers in the same zone, assign a unique name to each printer. By de-
fault, the network interface name is Canon NB-18GB (xxxxxx). (Here, xxxxxx is the last six digits of the print-
er's MAC address.)
*2: If zones have been created on the network, enter the name of the printer's zone. If there are no zones, leave the
asterisk * entry (for the default zone) as it is. If you enter a network zone name that does not match created
zones, the printer will not be detected by Macintosh computers. Consult your network administrator for informa-
tion on zone names.
7. Click OK to display the Network page.
Network Setting
>
Mac OS X Settings
>
Configuring the Printer's AppleTalk Network Settings iPF6300S
10
966
To Next Page
Loading...
Need help?
General