Configuring the Destination (Mac OS X)
Important
• AppleTalk is supported in Mac OS X 10.2.8–10.4.
Note
• The following procedures are based on Mac OS X 10.4. The method of configuring the destination varies
depending on the version of Mac OS X.
• The imagePROGRAF printer driver is not compatible with AppleTalk.
1. In System Preferences, click Network to display the Network window.
2. In Show, choose Built-in Ethernet. Next, click AppleTalk, select Make AppleTalk Active, and click Apply now.
3. Close the Network window and save the settings.
Configuring the Printer's AppleTalk Network Settings
Follow the steps below to configure the AppleTalk network settings.
1. Start the web browser and enter the following URL in the Location (or Address ) box to display the RemoteUI
page.
http://printer IP address or name/
Example: http://xxx.xxx.xxx.xxx/
2. Select Administrator Mode and click Logon.
Network Setting
>
Mac OS X Settings
>
iPF6300S Configuring the Printer's AppleTalk Network Settings
10
965
To Next Page
Loading...
Need help?
General