3
41
Recording
Recording Video and Photos
This section explains the basics of recording clips* and photos. For details on recording audio, refer to
Recording
Audio
(A 91).
* “Clip” refers to a single movie unit recorded with a single recording operation. You can also include metadata and News
Metadata (A 103) with the clip.
Recording
1 Open the lens barrier.
2Press the
Q
switch and set it to ON.
• The camera turns on in CAMERA mode and enters record standby mode ([STBY]). The power indicator
illuminates in green.
• The access indicators of card slots with a card inserted will illuminate momentarily in red. Then, the access
indicators of cards selected for recording will change to green.
3Press the REC button to begin recording.
• Recording starts. The tally lamp changes from green (power indicator) to red and the recording indicator at
the top of the screen changes from [STBY] to [ÜREC].
• The access indicator of cards used for recording will illuminate in red.
• You can also perform this function remotely using Browser Remote on a connected network device (
A
179).
4Press the REC button to stop recording.
• The clip is recorded and the camera enters record standby mode. The tally lamp goes out.
• The access indicator of cards selected for recording will change back to green.
SD card access
indicator
Tally lamp Power indicator