Shutter Speed
58
Changing the Shutter Speed Value
When the shutter speed mode is set to a mode other than OFF or automatic, you can set the shutter speed
manually.
1 Select the shutter speed mode (A 57).
2For [Speed] only: Select > [
v
Camera Setup] > [Shutter Increment] > [1/3 stop] or [1/4 stop].
3Adjust the shutter speed, angle value or clear scan frequency using the direct setting mode (A 50).
• You can also use direct touch control (A 49).
• Closing down the aperture when recording under bright conditions may cause the picture to appear soft or out
of focus. The following measures may be effective in avoiding the loss of sharpness due to diffraction.
- Using a denser ND filter (A 61).
- Using a faster shutter speed.
• When the camera is set to full auto mode (A 42) or you activate infrared recording (A 110), the shutter
speed mode will be set to automatic. If you activate infrared recording, the upper limit for the shutter speed will
be 1/250 (when > [
v
Camera Setup] > [High Sensitivity Mode] is set to [Off]) or 1/500 (when set to
[On]).
• When the shutter speed mode is set to [Slow], bright red, green or blue dots may appear on the screen. In
such case, use a faster shutter speed or select a lower ISO speed or gain value (A 59).
• When an RC-V100 Remote Controller is connected to the camera, you can change the shutter speed mode
with the remote controller’s SHUTTER SELECT button and the shutter speed value with the remote controller’s
SHUTTER
Í
/
Î
buttons.
Flicker Reduction
You can perform the following procedure to have the camera automatically detect and reduce flicker.
Select > [
v
Camera Setup] > [Flicker Reduction] > [Automatic].
• When recording under artificial light sources such as fluorescent, mercury or halogen lamps, the screen may
flicker depending on the shutter speed. You may be able to avoid flicker by setting the shutter speed mode to
[Speed] and the shutter speed to a value matching the frequency of the local electrical system: 1/50* or 1/100
for 50 Hz systems, 1/60 or 1/120 for 60 Hz systems.
* May not be available depending on the frame rate.
• When the frame rate is 23.98P and > [¢ Monitoring Setup] > [Run VF at x2 Speed] is set to [On],
[Flicker Reduction] cannot be used.
Using slow shutter mode
When recording in dark surroundings, you can obtain a brighter picture by using slow shutter mode. You can
also use this mode when you wish to add certain effects to your recordings, such as blurring the background
during panning shots or recording a moving subject with an afterimage trail.
• Image quality may not be as good as when using faster shutter speeds in brighter surroundings.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
