7 . ACCESSORIES AND OPTIONS
7.8
Challenger MT500B EU
7.2.4 - Use
Active mode
When the start switch key is in ON position, the last data
stored appears (Fig. 2).
1. Press the key 2 or 3 to access the available functions
(Fig. 3).
2. Turn the knob 14 to select the required function.
3. Press key 2 or 3 again to display the selection on the
lower or upper part of the screen: e.g.:
- Upper display: PTO speed,
- Lower display: Engine speed,
2 different functions can be displayed at the same
time.
NOTE: If the units of data displayed (Metric, UK Imper,
US Imper) do not correspond, return to the menu,
select UNITS and press key 2 or 3.
Memory mode (Fig. 4)
The Datatronic features 4 independent memories identi-
fied by a number (1 to 4) located to the left-hand side of the
screen, followed by digits or signs which can be introduced
by the operator. It is possible to record the total work done
with 4 different implements or to record the work done by
four different operators. e.g.: "1. SEEDER (minimum 10
characters).
Fig. 2
V913
1000
9 8 0
RPM
1 8 5 0
4. PLOUGH.
Fig. 3
2
3
14
V923
AREA WORKED
DISTANCE
HRS WORKED
COUNTER
COMP. MODE
EXT. TEMP.
TIME
DATE
SERVICE
COST/L
COST/AREA
UNITS
Fig. 4
V920
1. SEEDER.
To Next Page
Loading...
Need help?
General
