Challenger Techstar CVT MT525B Series User Manual

7 . ACCESSORIES AND OPTIONS
7.54
Challenger MT500B EU
7.11.2 - Recording a sequence
To record a sequence, press the key
«
1
(REC) when the
window (Fig. 101) is open. The recording window (Fig. 102)
is displayed.
Two recording modes are available:
- AUTOMATIC mode (4),
- MANUAL mode (5),
AUTOMATIC mode records a sequence based on the ac-
tions performed. Each action is displayed.
In MANUAL mode, the user records a sequence by manu-
ally selecting the actions to perform.
NOTE: If no memory is active, a warning message is
displayed (6). In this case, the sequence is recorded in
the HEADLAND application. If other recordings are per-
formed and if no memory is active, the previously
recorded sequence is overwritten. To record a
sequence in the memories application, see section 7.3.
(MEMORIES application).
7.11.2.1 - Recording a sequence in AUTOMATIC mode
Procedure to follow:
IMPORTANT: To record a sequence in automatic mode,
it must be started at the end of the field when you are
preparing to make a half turn (RECORD Fig. 103).
Indeed, the recording time for a sequence must not
exceed 2 minutes and 30 seconds.
• Press the key
«
1
(AUTO) when the window (Fig. 104) is
open. A new display appears (Fig. 105).
The question mark (7) indicates that recording can start.
AUTO
MAN
Z3A-819-08-04-B
Fig. 102
6
5
4
AUTOMATIC / MANUAL??
MEMORY OFF! ! !
RECORD
Z3A-824-08-04
Fig. 103
AUTO
MAN
Z3A-819-08-04-B
Fig. 104
AUTOMATIC / MANUAL??
MEMORY OFF! ! !
STOP
?
.....
Z3A-829-08-04-B
Fig. 105
7
AUTO RECORD

Challenger Techstar CVT MT525B Series Specifications

General

Brand	Challenger
Model	Techstar CVT MT525B Series
Category	Tractor
Language	English