Cisco Catalyst 6500 Series User Manual

CHAPTER
8-1
Catalyst 6500 Series Switch and Cisco 7600 Series Router Firewall Services Module Configuration Guide
OL-6392-01
8
Configuring IP Addresses, Routing, and DHCP
This chapter tells how to configure IP addresses, static routes, dynamic routing, and DHCP on the
Firewall Services Module (FWSM).
For routed and transparent mode, see the following sections:
• Configuring IP Addresses, page 8-1
• Configuring the Default Route, page 8-2
• Configuring Static Routes, page 8-3
• Configuring the DHCP Server, page 8-19
For routed mode only, see the following sections:
• Configuring OSPF, page 8-4
• Configuring RIP, page 8-18
• Configuring DHCP Relay, page 8-21
Note Multiple security contexts do not support dynamic routing protocols, such as RIP and OSPF.
Configuring IP Addresses
This section describes how to set the IP address(es) for routed mode or for transparent mode, and
includes the following topics:
• Assigning IP Addresses to Interfaces for a Routed Firewall, page 8-2
• Setting the Management IP Address for a Transparent Firewall, page 8-2

Cisco Catalyst 6500 Series Specifications

General

Brand	Cisco
Model	Catalyst 6500 Series
Category	Switch
Language	English