EasyManuals Logo
Home>Cisco>Switch>Catalyst 6500 Series

Cisco Catalyst 6500 Series User Manual

Cisco Catalyst 6500 Series
392 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #40 background imageLoading...
Page #40 background image
2-2
Catalyst 6500 Series Switch and Cisco 7600 Series Router Firewall Services Module Configuration Guide
OL-6392-01
Chapter 2 Configuring the Switch for the Firewall Services Module
Verifying the Module Installation
Verifying the Module Installation
To verify that the switch acknowledges the FWSM and has brought it online, view the module
information according to your operating system:
Cisco IOS software
Router> show module [
mod-num
| all]
The following example shows the output of the show module command:
Router> show module
Mod Ports Card Type Model Serial No.
--- ----- -------------------------------------- ------------------ -----------
1 2 Catalyst 6000 supervisor 2 (Active) WS-X6K-SUP2-2GE SAD0444099Y
2 48 48 port 10/100 mb RJ-45 ethernet WS-X6248-RJ-45 SAD03475619
3 2 Intrusion Detection System WS-X6381-IDS SAD04250KV5
4 6 Firewall Module WS-SVC-FWM-1 SAD062302U4
Catalyst operating system software
Console> show module [
mod-num
]
The following example shows the output of the show module command:
Console> show module
Mod Slot Ports Module-Type Model Sub Status
--- ---- ----- ------------------------- ------------------- --- ------
1 1 2 1000BaseX Supervisor WS-X6K-SUP1A-2GE yes ok
15 1 1 Multilayer Switch Feature WS-F6K-MSFC no ok
4 4 2 Intrusion Detection Syste WS-X6381-IDS no ok
5 5 6 Firewall Module WS-SVC-FWM-1 no ok
6 6 8 1000BaseX Ethernet WS-X6408-GBIC no ok
Note The show module command shows six ports for the FWSM; these are internal ports that are grouped
together as an EtherChannel. See the “Customizing the FWSM Internal Interface” section on page 2-11
for more information.
Assigning VLANs to the Firewall Services Module
This section describes how to assign VLANs to the FWSM. The FWSM does not include any external
physical interfaces. Instead, it uses VLAN interfaces. Assigning VLANs to the FWSM is similar to
assigning a VLAN to a switch port; the FWSM includes an internal interface to the Switch Fabric
Module (if present) or the shared bus.
See the following topics:
Prerequisites, page 2-3
Assigning VLANs in Cisco IOS Software, page 2-3
Assigning VLANs in Catalyst Operating System Software, page 2-5

Table of Contents

Other manuals for Cisco Catalyst 6500 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco Catalyst 6500 Series and is the answer not in the manual?

Cisco Catalyst 6500 Series Specifications

General IconGeneral
BrandCisco
ModelCatalyst 6500 Series
CategorySwitch
LanguageEnglish

Related product manuals