DESIGNER’S HANDBOOK 4189350049C EN Page 124 of 206
10.3.2 Warning setup
The menu below makes it possible to adapt the need of warnings to the actual application.
CAN bus error warning indicates a problem on
the CAN bus and should be set OFF if CAN bus
communication is not used.
Supply voltage monitor is mostly used in
systems where redundant power supply is used.
In systems with only one power supply,
monitoring of the used input should be ON.
Data lost pop-up is a supplement to the flashing
pointer, bar graph and/or digital readout. It
provides information of the type of problem (see
chapter 0
To Next Page
Loading...
Need help?
General
