Table 9. Performance(continued)
Option Description
System Isochronous Mode
Allows you to enable or disable this mode to reduce latency of
memory transactions at the expense of bandwidth. :
Click one of the options:
• Disabled(Default)
• Enabled
RAS Support
Allows you to report or log errors caused by memory failures, the
PCIe failures, CPU failures. The options are:
• Enable on Memory modules
• Enable on PCIe modules
• Enable on CPU modules
The options are not set by default.
Power management
Table 10. Power Management
Option Description
AC Recovery
Specifies how the computer will respond when AC power is applied after an AC power loss.
You can set the AC Recovery to:
• Power Off—Default
• Power On
• Last Power State
Auto On Time
Allows you to set the time at which the computer must turn on automatically.
Click one of the following options:
• Disabled—Default
• Every Day
• Weekdays
• Select Days
Deep Sleep Control
Allows you to define the controls when Deep Sleep is enabled.
Click one of the options:
• Disabled—Default
• Enabled in S5 only
• Enabled in S4 and S5
USB Wake Support
Allows you to enable USB devices to wake the system from standby.
• Enable USB Wake Support
This option is set by default.
Wake on LAN
This option allows the computer to power up from the off state when triggered by a special LAN signal.
Wake-up from the Standby state is unaffected by this setting and must be enabled in the operating
system. This feature only works when the computer is connected to AC power supply.
• Disabled - Does not allow the system to power on by special LAN signals when it receives a wake-up
signal from the LAN or wireless LAN.
• LAN Only - Allows the system to be powered on by special LAN signals.
• LAN with PXE Boot - Allows the system to power on and immediately boot to PXE when it receives
a wake-up packet sent to the system in either the S4 or S5 state.
110 System Setup
To Next Page
Loading...
Need help?
General
