Next steps
1 Install the cooling shroud.
2 Install the PSUs or PSU blank.
3 Follow the procedure listed in After working inside your system.
Related link
Installing the air shroud
Installing redundant power supply unit
Installing a cabled power supply unit
Installing a power supply unit
Installing a power supply unit blank
System battery
The system battery is used for low-level system functions such as powering the real-time and date settings of the system.
Replacing the system battery
Prerequisites
WARNING
: There is a danger of a new battery exploding if it is incorrectly installed. Replace the battery only with the same or
equivalent type recommended by the manufacturer. For more information, see the safety information that shipped with your
system.
1 Follow the safety guidelines listed in Safety instructions.
2 Follow the procedure listed in Before working inside your system.
3 If applicable, disconnect the power or data cables from expansion card(s).
Steps
1 Locate the battery socket. For more information, see the System board jumpers and connectors section.
CAUTION
: To avoid damage to the battery connector, you must rmly support the connector while installing or
removing a battery.
2 Use a plastic scribe to pry out the system battery.
130
Installation and Service Manual
Installing and removing system components
To Next Page
Loading...
Need help?
General