3–Adapter Management Applications
Windows Management Applications
101 CU0354602-00 L
Windows Diagnostic Test Descriptions
This section provides descriptions of the following Windows diagnostic tests.
Hardware Test
The hardware test checks the status of various hardware blocks, including
DMA engines, receive engine, and on-board processor meta cores.
Register Test
The register test performs device register read/write accesses.
Interrupt Test
The interrupt test checks the ability of the hardware to create an interrupt
and the ability of the driver to process the interrupt by forcing the generation
of a predetermined number of interrupts. The test succeeds if the device
generates the interrupts and the driver processes all interrupts expected.
External Loopback Test
The external loopback test verifies the transmit and receive path by sending
a packet out onto an external loopback cable.
Internal Loopback Test
The internal loopback test verifies the capability of the ProductLine to
internally loop back packets.
Link qaucli -nic -testlink [cna_port_inst]
Ping (IPv4) qaucli -nic -ping <cna_port_inst> <hostname_or_IPv4>
[<count> <pocket_size> <timeout_ms> <TTL>]
where the default values are <count>=5, <pocket_size>=525, <time-
out_ms>=1000, and <TTL>=30.
Register qaucli -nic -testregister [cna_port_inst]
Transceiver
DMI Data
qaucli -nic -trans [cna_port_inst]
Table 3-8. Running Windows Diagnostic Tests in the CLI (Continued)
Test Type Command
To Next Page
Loading...
Need help?
General
