Dell QMD8262-k User Manual

3–Adapter Management Applications
VMware Management Applications
111 CU0354602-00 L
# ethtool -t eth4
The test result is PASS
The test extra info:
Register_Test_on_offline 0
Link_Test_on_offline 0
Interrupt_Test_offline 0
Loopback_Test_offline 0
Linux Diagnostic Test Descriptions
 The internal loopback test performs internal packet loopback.
 The Flash test verifies the Flash read and write.
 The hardware test verifies that the hardware is running.
 The interrupt test
enables and disables the interrupt and functional verification
tests.
 The link test verifies that the port is linked, meaning that the port has a good
cable attached to the port and that other end of the cable is connected to an
operational Ethernet port, either another NIC port or a network device, such as a
switch.
 The register test verifies the NIC register read and write.
Linux Diagnostic Test Messages
Test information and PASS or FAIL messages are displayed for each of the tests
listed in “Linux Diagnostic Test Descriptions” on page 111.
VMware Management Applications
VMware management applications for the adapter include the following:
 VMware NIC Driver Management Applications
 User Diagnostics for VMware NIC Driver Management Applications
VMware NIC Driver Management Applications
This section provides the following information about the VMware NIC driver
management applications:
 Overview
 Using Switch Independent Partitioning Under ESX
Overview
VMware vSphere provides a CIM monitoring framework for both classic ESX and
ESXi. Use this framework to configure and manage Ethernet interfaces. On an
ESX Server, you can configure and manage Ethernet interfaces using a command
line interface. On an ESXi Server, use the remote CLIs (RCLIs).

Dell QMD8262-k Specifications

General

Brand	Dell
Model	QMD8262-k
Category	Network Card
Language	English