4 CU0354602-00 L
2 Driver Installation and
Configuration
Overview
This section provides links to the following information about the three
drivers—NIC, iSCSI, and FCoE—included with the adapter:
Windows Driver Installation and Configuration
Linux Driver Installation and Configuration
VMware Driver Installation and Configuration
If you need to update the Flash memory of multiple adapters simultaneously:
For the QConvergeConsole GUI, refer to the “Update the Flash Using
the Flash Update Wizard” topic in the QConvergeConsole Help System.
For the QConvergeConsole CLI, use the -flashsupport command to
update the Flash memory for all cards supported by the specified file (for
example, qaucli -pr nic -flashsupport -i ALL -a
p3p11179.bin).
When you disable the firmware (for example, during a firmware dump or
during a firmware update) in Windows or Linux with a QConvergeConsole
agent, multiple application messages are generated. These messages are
generated because the application cannot communicate with the adapter
while the firmware is disabled. After the firmware is re-enabled, the errors
will go away.
To Next Page
Loading...
Need help?
General
