3–Adapter Management Applications
General Management with QConvergeConsole
67 CU0354602-00 L
6. Select the Converged Network Port you want to configure.
7. Select 2, Configure IP Settings.
8. Complete the interactive list of settings as follows:
a. Enable IPv4 [on]: Press ENTER to accept the default.
b. DHCP to obtain IPv4 Network Information: [off]: Press ENTER to
accept the default.
c. IP_Address [ ]: Type the IP address of the initiator system and then
press ENTER.
d. IP_Subnet_Mask [255.255.255.0]: Type the appropriate subnet mask
and then press ENTER.
e. IP_Gateway [0.0.0.0]: Press ENTER to accept the default.
f. Enable IPv6 [off]: Press ENTER to accept the default.
9. On the options menu that appears, select 3, Save changes and reset HBA
(if necessary).
10. At the prompt for both ports, type Yes.
11. To return to the Converged Network Adapter (CNA) iSCSI Configuration
menu, type P and press ENTER and then type P and press ENTER again.
12. On the Converged Network Adapter (CNA) iSCSI Configuration menu,
select 4, Target Configuration.
13. Select the same Converged Network Port you selected in Step 6.
14. Select 6, Add a Target.
15. Complete the interactive list of settings as follows:
a. IPv6 Target? [off]: Press ENTER to accept the default.
b. TGT_iSCSI_Name [ ]: Type the iSCSI Qualified Name (IQN) of the
iSCSI target to connect to and then press ENTER.
c. TGT_Port [3260]: Press ENTER to accept the default.
d. TGT_TargetIPAddress [0.0.0.0]: Type the IP address of the target
and then press ENTER.
16. On the options menu that appears, select 12, Save Target/CHAP Changes.
The iSCSI initiator is now configured to connect to the iSCSI target.
Configuring the ESX iSCSI Initiator
The software iSCSI initiator must be enabled for ESX/ESXi to be able to use it for
accessing iSCSI storage.
To configure an ESX/ESXi initiator:
To Next Page
Loading...
Need help?
General
