Digi AnywhereUSB 2 Plus User Manual

Configure the AnywhereUSB Plus Hub from the CLI settime
AnywhereUSB® Plus User Guide
147
settime
Purpose
Sets the Coordinated Universal Time (UTC) and/or system time and date on a Digi device.
All Digi devices maintain time and date as the UNIX epoch (00:00:00, January 1, 1970) plus device up-
time. On devices with no real-time clock (RTC), date and time revert to the UNIX epoch on each reboot
or power-cycle. On devices with a RTC, date and time is the UNIX epoch plus time since initial power-
up.
On a Digi device with no real-time clock and no configured clock source, time and date are completely
local to the device and have limited usefulness since they are not persistent over reboots/power-
cycles.
On a device with a RTC and no configured clock source, time and date are also local to the device, but
they are meaningful because they are persistent.
On a device with a configured clock source, time and date received from a clock source are expected
to be UTC.
Syntax
set time [ options ]
Options
time=hh:mm:ss|hh:mm
The time. Hours can range from 00 to 23, minutes can range from 00 to 59, and seconds can range
from 00 to 59. If omitted, all default to 00.
date=mm.dd.yy
The date. Month can range from 01 to 12, day can range from 01 to 28, 29, 30, or 31, depending on the
month and leap year, and year can range from 00 to 36, representing the years 2000 through 2036.
timezone=string
Enter the time zone name, such as CST6CDT or Chicago.
ntp_enable=on|off
Enable or disable time server synchronization.
serverN=ntp server name
The name of the NTP server, where N is the server number.
N=server index [1-4]
Specify the number of the NTP server.
Example
Set NTP server #1 to 0.time.digi.com
#> set time server1=0.time.digi.com

Digi AnywhereUSB 2 Plus Specifications

General

Brand	Digi
Model	AnywhereUSB 2 Plus
Category	Switch
Language	English