Configure the AnywhereUSB Manager from the
command line
You can configure and control the AnywhereUSB Manager from the command line.
Prerequisites
n Service: If you run the AnywhereUSB Manager as a service, you need to be an Administrator.
n Stand-alone: If you run the AnywhereUSB Manager as a stand-alone, you need to be the same
user that was logged in during the installation process or an Administrator. If you are not an
Administrator, and you try to configure the AnywhereUSB Manager from a command line with
the "Run as Administrator" option selected, the commands will fail.
AnywhereUSB® Plus User Guide
80
To Next Page
Loading...
Need help?
General
