Configure the AnywhereUSB Manager from the command line connect group
AnywhereUSB® Plus User Guide
90
connect group
Purpose
You can connect to a group so that you have access to the ports in the group. Once you have
connected to a group, no one else can connect to that group. You cannot connect to a group that is
already is use.
When you connect to a group, you are automatically connected to all of the ports in the group to which
you are allowed access.
Syntax
>awusbmanager connect group,<
address
>
The [address] is the address of the group to which you want to connect.
Examples
Run the list command to determine the address for the group to which you want to connect. In this
example, you will connect to Group 1.
AnywhereUSB Manager, below are the available devices:
AW02-000001 (AW02-000001.local.:18574)
Group 2 (AW02-000001.2) (In-use by you)
Group 1 (AW02-000001.1)
U3 Cruzer Micro (AW02-000001.1101)
* means Autoconnect enabled, + means Autoconnect inherited
Auto-Find: enabled
Autoconnect All: disabled
AnywhereUSB Manager not running as a service
Run the connect group command.
>awusbmanager connect group,AW02-000001.1
Run the list command again to verify that you are connected to the group and to all of the ports in the
group to which you are allowed access.
AnywhereUSB Manager, below are the available devices:
AW02-000001 (AW02-000001.local.:18574)
Group 2 (AW02-000001.2) (In-use by you)
Group 1 (AW02-000001.1) (In-use by you)
U3 Cruzer Micro (AW02-000001.1101) (In-use by you)
* means Autoconnect enabled, + means Autoconnect inherited
Auto-Find: enabled
Autoconnect All: disabled
AnywhereUSB Manager not running as a service
To Next Page
Loading...
Need help?
General
