Configure the AnywhereUSB Manager from the command line autoconnect group
AnywhereUSB® Plus User Guide
84
autoconnect group
Purpose
Enable the auto connect feature for a specified group. This feature ensures that when you start the
AnywhereUSB Manager as a stand-alone or when it starts at Windows startup if installed as a
service, you are automatically connected to all of the groups to which you are allowed access that
have auto connect enabled.
When you enable auto connect for a group, an asterisk displays next to the group name. In addition,
any devices in the group inherit the auto connect feature, and will also be automatically connected. A
plus sign displays next to the devices when the auto connect feature is inherited.
You can disable the auto connect feature for the group if needed.
Note For more information about auto connect, see Configure auto connect.
Syntax
>awusbmanager autoconnect group,<
address
>
The [address] is the address of the group for which you want to enable the auto connect feature.
Examples
Run the list command to verify the current state of the auto-connect feature for a group and to
determine the address for a group. In this example, Group 2 has the auto connect feature enabled, so
an asterisk displays next to the group name. The auto connect feature is not enabled for Group 1, so
an asterisk does not display.
The [address] for a group is the name of the Hub appended by the number of the group. In this
example, the auto connect feature will be enabled for Group 1, so the group name is highlighted
below.
AnywhereUSB Manager, below are the available devices:
AW02-000001 (AW02-000001.local.:18574)
* Group 2 (AW02-000001.2) (In-use by you)
Group 1 (AW02-000001.1) (In-use by you)
U3 Cruzer Micro (AW02-000001.1101)
* means Autoconnect enabled, + means Autoconnect inherited
Auto-Find: enabled
Autoconnect All: disabled
AnywhereUSB Manager not running as a service
Run the the autoconnect group command.
>awusbmanager autoconnect group,AW02-000001.1
Run the list command again to verify that the auto connect feature has been enabled. An asterisk
displays next to the group name. A plus sign displays next to the names of the devices in the group to
show that the auto connect feature is inherited from the group.
To Next Page
Loading...
Need help?
General
