Administrators: Configure the AnywhereUSB® Plus in the web user interface Configure device identity settings
AnywhereUSB® Plus User Guide
67
4. When you have found the Hub, click Stop. The "Find Me LED Status" message changes to not
blinking, and the message "The Find Me LEDis stopped" appears at the top of the page.
Configure device identity settings
You can configure the device description, contact, and location information for the Hub in the System
Configuration page. This feature is useful to identify a specific Hub when working with a large
number of Hubs in multiple locations. The information entered on this page appears in the Home
page.
1. Open the web UI.
2. Click System from the Configuration section. The System Configuration page appears.
3. Enter the following information:
n Description: An identifying description of the Hub.
n Contact: Any contact information for a person that can manage the Hub, such as the
administrator name and contact information.
n Location: The physical location of the Hub.
4. Click Apply to apply and save the changes.
Allow the Hub to connect to Remote Manager
You can use Digi® Remote Manager to view your Hubs and manage the information sent from the Hub
to Remote Manager. By default, the Hub is configured to connect to Remote Manager, and Remote
Manager is configured to allow a connection with the Hubs.
You can enable access for the Hub to Remote Manager and specify reconnect time and keepalive
intervals in the Remote Manager Configuration page. You can view information about the connection
to Remote Manager in the System Statistics page and in the Connections Management page.
To Next Page
Loading...
Need help?
General
