To Next Page

To Previous Page

Configure the AnywhereUSB Manager from the command line device name

AnywhereUSB® Plus User Guide

device name

Purpose

Change or assign the local name of a device.

Syntax

>awusbmanager device name,<

address

>,<

new name

The <device name> is the device's address.

The <new name> is the new local name for the device.

Examples

Run the list command to determine the device's address.

AnywhereUSB Manager, below are the available devices:

AW02-000001 "Hub 1" (AW02-000001.local.:18574)

Group 2 (AW02-000001.2) (In-use by you)

Group 1 (AW02-000001.1) (In-use by you)

U3 Cruzer Micro (AW02-000001.1101)

* means Autoconnect enabled, + means Autoconnect inherited

Auto-Find: enabled

Autoconnect All: disabled

AnywhereUSB Manager not running as a service

Run the device name command.

>awusbmanager device name,AW02-000001.1101,USBStick

Run the list command again to verify the name change.