Administrators: Configure the AnywhereUSB® Plus in the web user interface Reboot the Hub
AnywhereUSB® Plus User Guide
73
4. Determine whether you want to retain the current DHCP and manual configuration settings. IP
configuration option: automatic (automatically obtain an IPaddress each time you power on
the Hub) or static (manually assign an IPaddress).
n Do not select the Keep Stored IPConfiguration option to remove the current IP
configuration option. In this situation, the DHCP (Auto IP) process is used. For more
information about DHCP and Auto IP, see Automatically obtain an IPaddress for the
Hub. This is the default.
n Select the Keep Stored IPConfiguration option to retain the current IPconfiguration
option. The IP, netmask, gateway, and DNS values will be used for the network
configuration. These manual values are kept in the configuration settings even if you
are currently using DHCP, so you can flip back and forth.
5. Click Restore. The Hub is rebooted.
6. You must re-deploy the Hub.
Reboot the Hub
You can reboot the Hub if needed. For example, changes to some Hub settings require saving the
changes and rebooting the Hub for the changes to take effect on the Hub.
Note If the Set Time option is selected in the Time Configuration page, and the Hub is rebooted, the
Set Time option is de-selected and the time reverts to the last time stamp that was written to the
Hub log file. If you want to more accurately set the time, you should either configure time server
synchronization or manually re-set the time.
1. Open the web UI.
2. Select Reboot from the Administration section. The System Reboot Confirmation page
appears.
3. Click Reboot.
4. Wait approximately 15 seconds for the reboot to complete. When the reboot is complete, all
the LEDs turn on and then turn off, leaving the power LEDs on. For the AnywhereUSB 24 Plus
model, one or both of the power LEDs will be on.
Uninstall the AnywhereUSBManager
You can uninstall the AnywhereUSBManager if needed.
1. Locate the AnywhereUSBManager installer.
n If you saved the installer when you originally installed the AnywhereUSBManager,
navigate to that location on your computer.
To Next Page
Loading...
Need help?
General
