Patient Monitor User Manual Recording
- 201 -
Chapter 24 Recording
A thermal dot matrix recorder is used for the monitor and can support many recording types and
output patient information, measurement data, review data waveform and so forth.
1 Recording indicator
2
Paper feeding key: press this key to start or stop feeding recording
paper without outputting anything on the paper
3 Paper outlet
4 Recorder door
NOTE:
If the blank recording paper is insufficient after recording is stopped, the user can press
the paper feeding key on the recorder to feed more paper.
24.1 Performance of the Recorder
Waveform record is printed at the rate of 12.5 mm/s, 25 mm/s or 50 mm/s.
48 mm record width and 50 mm record paper width.
It can record up to three waveforms.
User-selectable real-time recording time and waveform.
Auto recording interval is set by the user, and the waveform is in accordance with the real
time recording.
NOTE:
It is suggested that the user should not use the recorder when the low battery displays, or
the monitor may be turned off automatically.
1
3
4
2
4
To Next Page
Loading...
Need help?
General
