Patient Monitor User Manual User Interface
- 86 -
8.9.1 Opening the Bed View Window
Before opening the Bed View window, make sure the bed view function is configured on your
monitor. To open the Bed View window, select Menu > Display Setup and choose Bed View in
the View Selection list.
8.9.2 Settings of the Bed View Window
Click on the Bed View window to open the ViewBed Setup menu on which you can
Assign a bed to be viewed by selecting the bed No. in the Bed No. list.
Select the waveform to be displayed on the window in the Wave Type list.
Use the buttons
and to view more numeric information of parameters in the
window.
8.10 Changing Parameter and Waveform Colors
The user can set the display colors of parameter and waveform as desire. To change the display
color, please select Menu > Maintenance > User Maintain, enter the required password. Then
select Color Setup to make color changes on parameter and waveform.
8.11 Displaying the Timer
The monitor has the timer function to notify you when a preset time period is expired. To display
the timer on the main interface,
1. Select the shortcut key on the screen directly, or select Menu > System Setup >
Module Switch.
2. Select Timer from the popup interface. Exit the menu and the screen will adjust the
parameters automatically.
In the timer displaying area, the user can set the timer counting direction. Select Timer Setup >
Timing Direction.
Count Down: to display the remaining time. When the user selects Count Down, Timing
Duration shall be set simultaneously. The timing duration can be set between 0 and 120
hours. Default setting is 5 min. When the remaining time is 30 seconds, the time turns red,
prompting you that the timing duration is to expire. When the timing duration expires, the
monitor issues a reminder tone. To set the reminder tone volume, select Menu > System
Setup > Reminder Volume.
Count Up: to display the elapsed time.
When the Timing Direction is Count Down, the user can select Start/Pause/Resume or Cancel
to start/pause/resume or end the timer; When the Timing Direction is Count Up, the user can
select Start or Cancel to start or clear the timer.
To turn off the timer displaying, the user can remove the timer in the module switch menu.
To Next Page
Loading...
Need help?
General
