October 2019
Installation, Operation and Maintenance Manual
MAN-02-04-97-0713-EN Rev. 1
46
Section 6: Local Controls
Local Controls
Maintenance
This menu includes all diagnostic and historic data which can assist the operator if failures
occur or during maintenance operations. The Maintenance menu also includes the
“Set password” routine.
List of routines:
• Set-up Mode
— set new password
— clear alarm log
— set torque prole reference
— set torque curve reference
— clear recent data log
— set maintenance date
— set data logger
• View Mode
— alarm log
— torque prole
— torque curve
— operation log
— maintenance date
— data logger
The parameters appear on the alphanumeric display in the same order in both view and
set-up mode. At the end of each routine, the program will automatically return to the
beginning of the routine and the operator can choose to either re-enter (by pressing YES)
or move on to a next routine (by pressing NO).
6.3 Entering the View Mode
The existing actuator conguration should be checked before commissioning.
The parameters are congured at the factory according to standard settings, or to
customer requirements. No password is required to access view mode, but no change of
parameters can be made.
• Ensure that mains power is supplied.
• Move the 3-position selector to OFF and then simultaneously press OPEN/YES
and STOP.
• The display shows the present language. Press YES to conrm or NO to scroll
through the list of available languages. Press YES to select a new language
Press YES to conrm.
• Press NO to scroll through the list of available menus (actuator set-up, nameplate,
valve data, maintenance) and then press YES to select the desired menu.
• Press NO to scroll through the list of available routines and press YES to select the
routine where the parameter to be changed is located.
• Press NO to scroll through the list of parameters and press YES to view the value.
To Next Page
Loading...
Need help?
General
