Emerson Bettis XTE3000 User Manual

Installation, Operation and Maintenance Manual
MAN-02-04-97-0713-EN Rev. 1 October 2019
71
Section 9: Set-Up Routines
Set-Up Routines
9.3.1 Set Password
The actuator is supplied by Emerson with the default password (“0 0 0 0”). The Set
Password routine allows the user to enter a different password consisting of 4 alphanumeric
characters. After entering the new password, the old one becomes invalid. Therefore, it is
mandatory to NOT FORGET THE PASSWORD (or store the password in a secure location)
after the default one has been modied. Losing the new password makes it impossible to
enter the set-up menu and to congure the actuator.
Configuration procedure
• Move the local selector to OFF and then simultaneously press OPEN and STOP.
Select the language and enter the password according to the instructions
(see “Entering the set-up mode”). When the message displayed is “SET-UP MODE
OK?” press YES. Press NO to scroll through the list of available menus and then
press YES to select the "Maintenance" menu.
• Press NO to scroll the list of available routines and then press YES to select
"Set Password". Press YES again to select "Enter New Password".
• Enter the new password one digit at a time. Press YES if the digit is correct;
otherwise, press NO to scroll through the list of available characters and then
press YES to select. Enter 4 digits. When the display shows the message "Password
Changed", the old password is no longer valid.
9.3.2 Clear Alarm Log
Clear procedure
• Move the local selector to OFF and then simultaneously press OPEN and STOP.
Select the language and enter the password according to the instructions
(see “Entering the set-up mode”). When the message displayed is “SET-UP MODE
OK?” press YES. Press NO to scroll the list of available menus and then press YES to
select the "Maintenance" menu.
• Press NO to scroll through the list of available routines and then press YES to select
"Clear Alarm Log".
• Press YES to clear the alarm log.
9.3.3 Set Torque Reference
The set torque prole reference routine allows transfer of the last torque prole to the
reference prole registers. The old reference data are lost and the new data are used as a
new reference torque prole.
• Move the local selector to OFF and then simultaneously press OPEN and STOP.
Select the language and enter the password according to the instructions
(see “Entering the set-up mode”). When the message displayed is “SET-UP MODE
OK?” press YES. Press NO to scroll through the list of available menus and then
press YES to select the "Maintenance" menu.
• Press NO to scroll through the list of available routines and then press YES to select
"Set Torque Reference".
• Press YES to update the torque reference data.

Emerson Bettis XTE3000 Specifications

General

Brand	Emerson
Model	Bettis XTE3000
Category	Controller
Language	English