205
FAULTS AND REMEDIAL ACTIONS
1. Warning and fault messages
Operation_Pic_number:1
Warning and fault messages are indicated on the multiple display. The warning lamp also flashes and
a warning tone is sounded.
Fault codes are stored and can be called up for more accurate definition of the fault. These codes are
memorised to be called up in the workshop for rapid fault location.
In normal status, display shows the clock (A) and the number of operating hours (B).
1.1 Warning messages
No fault code, no storage.
Text-module
Calling up several concurrently existing warnings
Fault-module
Press the button to show the symbols for existing warning messages one after the other. If the
button is not pressed for 3 seconds, the symbol for the warning message indicated first
reappears.
1. Engine temperature
Display accompanied by a continuous beep and warning light.
Unload the engine immediately, then switch off.
Cause Remedial Action
Clogged radiator fins. Blow or spray fin from inside to outside.
Not enough cooling water. Top up with warm water while the engine is
running.
V-belt is loose or torn. Re-tension or change the belt.
Thermostat does not open. Replace thermostat (workshop task).
Coolant circuit dirty. Clean out the inside of the system with hot
flushing liquid, e.g. P3 (at workshop).
Viscous fan faulty. Replace viscous fan (at workshop).
Fig.1
To Next Page
Loading...
Need help?
General
