2-08
IGNITION SYSTEM
2-08
DIAGNOSIS AND TESTING (Continued)
TEST STEP
RESULT
ACTION TO TAKE
4 BALLAST RESISTOR
1
1. Separate and inspect ignition module two wire
0.8 to 1.6 ohms
Problem is either
connector with RED and WHITE wires.
intermittent or not in
2. Disconnect and inspect ignition coil connector.
ignition system.
GO to 5.
3. Measure ballast resistor between BAIT terminal of
ignition coil connector and wiring harness connector
Less than 0.8 or greater
Replace ballast resistor.
mating with RED module wire. than 1.6 ohms
4. Reconnect all connectors.
IGNITION
MODULE
STARTER RELAY
DISTRIBUTOR
NOTE:
WIRE SEQUENCE
HAS BEEN ARRANGED
TO SIMPLIFY
SCHEMATIC.
A
6379-A
To Next Page
Loading...
Need help?
General
