Ford LSG 875 User Manual

3-14
FUEL SYSTEM
3-14
MODEL 2300 2-V CARBURETOR (Continued)
let Wrench
MAIN JETS
v1023-A
3.
Remove the fuel level adjustment lock screw
and gasket. Turn the adjusting nut coun-
terclockwise and remove the lock nut and
gasket, and the fuel inlet needle and seat
assembly. Do not disassemble the fuel in-
let needle and seat. They are matched,
and are replaced as an assembly.
4. Using needle nose pliers, remove the float
retainer.
5. Slide the float off the shaft. Remove the
spring from the float.
6. Remove the fuel level sight plug and gasket.
Remove the fuel inlet fitting, gasket, and fil-
ter screen.
7. Invert the fuel bowl and remove the acceler-
ating pump cover, diaphragm, and spring.
The accelerating pump inlet ball check is not
removable.
V1024- A
Main Body
1.
Invert the carburetor and remove the throttle
body from the main body. Disconnect the
choke rod from the choke control shaft lever
assembly by pushing the rod toward the
main body and releasing it from the lever.
Discard the throttle body gasket.
2. Remove choke rod and seal. Unless the
choke valve is bent or damaged, DO NOT
remove.
NOTE: The choke plate screws are staked to
prevent loosening and care is necessary to
avoid breaking or stripping the threads in the
choke shaft. If necessary to remove plate, re-
move staking with a file before loosening
screws.
3. Remove the accelerating pump discharge
nozzle from the main body.
4.
Invert the main body and let the accelerating
pump discharge needle fall into the hand.
Remove the throttle operating shaft housing
back-up plate and gasket.
5. If it is necessary to remove the throttle
plates, lightly scribe both throttle plates
along the throttle shaft and mark each throt-
tle plate and its corresponding barrel to in-
sure proper installation. Remove the throttle
plates. Remove the retainer from each end
of the shaft. Slide the throttle shaft out of the
throttle body.
V1026-A
Throttle Operating Shaft Housing
1. Remove the engine idle speed adjusting
screw and spring. Remove the fast idle ad-
justing pin and screw.
2. Loosen the throttle lever screw. Remove the
throttle lever retaining pin. Remove the throt-
tle lever and the accelerating pump cam.
Remove the throttle pick-up lever and swivel
assembly.
3. Remove the throttle shaft retainer and slide
the throttle shaft out of the housing.

Ford LSG 875 Specifications

General

Brand	Ford
Model	LSG 875
Category	Engine
Language	English