Fronius CMT 4000 Advanced User Manual

0 neutral arc
+ soft, low-spatter arc
Gas pre-flow time
Gas post-flow time
Feeder creep speed
The settings for the background parameters gas pre-flow time, gas post-flow time and
feeder creep speed are described in the Setup menu.
Adjusting para-
meters for cor-
rection
1
Press the Parameter selection button to select the parameter you wish to correct
2
Use the adjusting dial to set the selected parameter to the desired value. The para-
meter value is displayed in the digital display located above it.
Remarks on the
Standard control
panel
It is not possible to correct the arc length on the Standard control panel.
However, you can set the arc force correction as a background parameter in the Setup
menu.
103
EN
Toowoomba Welding Supplies : tweld.com.au : Ph +61 7 4659 0044

Fronius CMT 4000 Advanced Specifications

General

Brand	Fronius
Model	CMT 4000 Advanced
Category	AC Power Distribution
Language	English