Fronius CMT 4000 Advanced User Manual

Commissioning the TPS 2700
General Commissioning the TPS 2700 power source is described by reference to a manual gas-
cooled MIG/MAG application.
Recommendation
for water-cooled
applications
- Use the PickUp trolley
- Fit the cooling unit to the PickUp trolley
- Fit the TPS 2700 power supply to the cooling unit
- Only use water-cooled welding torches with an external water connection
- Connect the water connections on the welding torch directly to the cooling unit
Connecting the
gas cylinder
WARNING!
If gas cylinders topple over, there is a risk of very serious injury and damage.
Place gas cylinders on a solid, level surface so that they remain stable. Secure gas cylin-
ders to prevent them from falling over.
Observe the safety rules of the gas cylinder manufacturer.
Connecting the gas hose to the TPS 2700
1
Place the gas cylinder on a solid, level
surface in such a way that it remains
stable
2
Secure the gas cylinder to prevent it
from toppling over (but not around the
neck of the cylinder)
3
Take the protective cap off the gas cyl-
inder
4
Briefly open the gas cylinder valve to
blow off any dust or dirt
5
Check the seal on the pressure regu-
lator
6
Screw the pressure regulator onto the
gas cylinder and tighten it
7
Connect the pressure regulator to the
shielding gas connection on the power
source using the gas hose
NOTE!
US devices are supplied with an adapter for the gas hose:
▶
Glue in or seal the adapter
▶
Test the adapter to ensure that it is gas tight.
82
Toowoomba Welding Supplies : tweld.com.au : Ph +61 7 4659 0044

Fronius CMT 4000 Advanced Specifications

General

Brand	Fronius
Model	CMT 4000 Advanced
Category	AC Power Distribution
Language	English