MIG/MAG standard manual welding
General The MIG/MAG standard manual welding process is a MIG/MAG welding process with no
Synergic function.
Changing one parameter does not result in any automatic adjustments to the other para-
meters. All of the variable parameters must therefore be adjusted individually, as dictated
by the welding process in question.
The inputs required for MIG/MAG standard manual welding are described by reference
to the "Comfort" control panel.
Available para-
meters
In MIG/MAG standard manual welding, the following parameters are available:
Wire feed speed
0.5 m/min (19.69 ipm) - maximum wire feed speed
e.g. 22.0 m/min (866.14 ipm)
Welding voltage
TPS 3200 / 4000 / 5000: 10.0 - 40.0 V
TPS 2700: 10.0 - 34.0 V
Dynamic correction
for influencing the short-circuiting dynamic at the instant of droplet transfer
Welding current
only the actual value is displayed
MIG/MAG stand-
ard manual weld-
ing
1
Press the Process button to select the MIG/MAG standard manual welding process
2
Press the Material button to select the filler metal and shielding gas used
The assignment of SP1 and SP2 depends on the welding database used for the
power source.
3
Press the Wire diameter button to select the diameter of the wire electrode
The assignment of SP depends on the welding database used for the power source.
104
Toowoomba Welding Supplies : tweld.com.au : Ph +61 7 4659 0044
To Next Page
Loading...
Need help?
General
