Before installation and commissioning
Safety
WARNING!
Danger from incorrect operation.
Possible serious injury and damage to property.
â–¶
Do not use the functions described here until you have read and completely under-
stood these Operating Instructions.
â–¶
Do not use the functions described here until you have fully read and understood all
of the Operating Instructions for the system components, in particular the safety
rules!
Proper use The power source may only be used for MIG/MAG, MMA and TIG welding. Any use
above and beyond this purpose is deemed improper. The manufacturer shall not be held
liable for any damage arising from such usage.
Proper use also includes:
- following all the information in the operating instructions
- carrying out all the specified inspection and servicing work
Setup regulations The device is tested to IP 23 protection, meaning:
- protection against penetration by solid foreign bodies with diameters > 12.5 mm
(0.49 in.)
- protection against direct sprays of water at any angle up to 60° from the vertical
The device can be set up and operated outdoors in accordance with IP23. Avoid direct
wetting (e.g. from rain).
WARNING!
If one of these devices topples over or falls it could cause serious or even fatal
injury.
â–¶
Place devices, upright consoles and trolleys on a solid, level surface in such a way
that they remain stable.
The venting duct is a very important safety feature. When choosing the installation loca-
tion, ensure that the cooling air can enter and exit unhindered through the air ducts on
the front and back of the device. Any electroconductive metallic dust (e.g. from grinding
work) must not be allowed to get sucked into the device.
Mains connection The devices are designed to run at the mains voltage specified on the rating plate. If your
version of the device does not come with mains cables and plugs ready-fitted, these
must be fitted in accordance with national regulations and standards. For details of fuse
protection of the mains lead, please see the Technical Data.
75
EN
Toowoomba Welding Supplies : tweld.com.au : Ph +61 7 4659 0044
To Next Page
Loading...
Need help?
General
