4
Press and hold the Store button
NOTE!
If the selected program location already has a job stored in it, then this exist-
ing job will be overwritten with the new job.
This action cannot be undone.
The left-hand digital display reads “Pro” - the job is stored in the program location
you have just selected.
"PrG" appears on the left-hand digital display to indicate that the job is now stored.
NOTE!
The parameters from the Setup menu are also stored for each job with the
exception of the following functions:
▶
Push-pull unit
▶
Cooling unit switch-off
▶
Measuring the welding circuit resistance
▶
Measuring the welding circuit inductivity
5
Release the Store button
6
Briefly press the Store button to exit from the Job menu
The power source switches to the setting selected before the job was stored.
Retrieving a job
NOTE!
Before retrieving a job, make sure that the welding system has been installed and
set up for the job.
127
EN
Toowoomba Welding Supplies : tweld.com.au : Ph +61 7 4659 0044
To Next Page
Loading...
Need help?
General
