Setup regulations 75
Mains connection 75
Connecting up the mains cable on US power sources 77
General 77
Stipulated mains cables and strain-relief devices 77
Safety 77
Connecting the mains cable 77
Replacing the strain-relief device 79
Start-up 80
Safety 80
Remarks on the cooling unit 80
Information on system components 80
Overview 81
Commissioning the TPS 2700 82
General 82
Recommendation for water-cooled applications 82
Connecting the gas cylinder 82
Establishing a ground (earth) connection 83
Connecting the welding torch 83
Inserting/replacing feed rollers 84
Inserting the wirespool 84
Inserting the basket-type spool 85
Feeding in the wire electrode 86
Setting the contact pressure 87
Adjusting the brake 87
Design of the brake 88
Commissioning the TS 4000 / 5000, TPS 3200 / 4000 / 5000, TIME 5000 Digital 89
General 89
Fitting the system components (overview) 89
Fixing the strain-relief device in place 90
Connecting the interconnecting hosepack 90
Connecting the gas cylinder 91
Establishing a ground (earth) connection 92
Connecting the welding torch 92
Other tasks 92
Commissioning the CMT4000 Advanced 93
Fitting the system components (overview) 93
Connecting the interconnecting hosepack, CMT welding torch and wire buffer 93
Other tasks 94
Preparing the wire-feed unit 94
Welding 95
MIG/MAG modes 97
General 97
Symbols and their explanations 97
2-step mode 98
4-step mode 98
Special 4-step mode 99
Spot welding 99
MIG/MAG welding 100
Safety 100
General tasks before MIG/MAG welding 100
Overview 100
MIG/MAG synergic welding 101
General 101
MIG/MAG synergic welding 101
Corrections during welding 102
Adjusting parameters for correction 103
Remarks on the Standard control panel 103
MIG/MAG standard manual welding 104
General 104
5
EN
Toowoomba Welding Supplies : tweld.com.au : Ph +61 7 4659 0044
To Next Page
Loading...
Need help?
General
