Power Source
67
Product Overview
2
z
When the Finisher-B1 (optional) is installed.
z
The “Please wait...” message indicates that the machine is warming up. The machine is not available during
warming up.
z
If the machine does not power on, check the following:
z
The power cord is plugged in.
z
The main power is switched on.
z
The <RESET> button is in the depressed position.
Switching the Power Off
The following describes how to switch the power off.
z
If the power is switched off, all the services of the machine will stop. When using the machine throughout the
day for jobs such as receiving fax, do not switch the power off.
z
You can set the machine to be switched off automatically at the same time every day. For more information,
refer to "Tools" > "Common Service Settings" > "Power Saver Settings" >"Scheduled Power Off" in the
Administrator Guide.
1 Before switching the power off, make sure that the machine has completed all copy or print
jobs. Then, make sure that the <Data> indicator does not blink.
z
Do not switch the power off in the following situations. If the power is switched off, the processing data may
be erased.
z
While data is being received
z
While a job is being printed
z
While a job is being copied
z
While a job is being scanned
z
When switching the power off, wait 5 seconds after outputs have been delivered.
To Next Page
Loading...
Need help?
General
