258 Faxing
Sending a Delayed Fax
The Delayed Start mode can be used to save scanned documents for transmission at a specified time to take
advantage of lower long distance rates.
1 Load the document(s) face up with top edge in first into the DADF.
OR
Place a single document face down on the document glass, and close the document cover.
See also:
• "Loading an Original Document" on page 253
2 Press the (Services) button.
3 Select Fax.
4 Adjust the document resolution to suit your fax needs.
See also:
• "Adjusting the Document Resolution" on page 255
• "Adjusting the Document Contrast" on page 255
5 Select the Options tab, and then select Delayed Send.
6 Select On.
7 Enter the start time using the number pad, and then select OK.
8 Select the Fax tab.
9 Enter the fax number of the recipient using the number pad.
You can also use speed or group dial numbers.
See also:
• "Automatic Dialing" on page 265
10 Press the (Start) button to scan data.
Once Delayed Start mode is activated, your printer stores all of the documents to be faxed into its memory and
sends them at the specified time. After faxing in the Delayed Start mode is complete, the data in the memory is
cleared.
NOTE:
• If you turn off and on the printer, the stored documents are sent as soon as the printer is activated.
To Next Page
Loading...
Need help?
General
