308 Using the Operator Panel Menus and Keypad
Email Server Address Book
Purpose:
To specify whether to search the e-mail addresses from the Address Book for the LDAP server.
Values:
NOTE:
• You can search the e-mail addresses only from the Address Book that is local when Email Server Address Book is set
to Off.
Power on Wizard
Purpose:
To perform initial setup for the printer.
•Timers
Purpose:
To configure timer settings.
Control Panel
Purpose:
To automatically reset the settings for Copy, Scan, Fax, E-mail, or Print to the default settings and return to the
standby mode after you do not specify any settings for the specified time.
Values:
Fault Timeout
Purpose:
To specify the amount of time the printer waits before canceling a job that stops abnormally. The print job is
cancelled if the time-out time is exceeded.
Values:
Off
*
Does not search the e-mail addresses from the Address Book for the LDAP
server.
On Searches the e-mail addresses from the Address Book for the LDAP server.
45 Seconds
*
1 Minute
2 Minute
3 Minute
4 Minute
Off Disables the fault time-out.
On
*
60 sec
*
Sets the amount of time the printer waits before canceling a job that
stops abnormally.
3-300 sec
To Next Page
Loading...
Need help?
General
