300 Using the Operator Panel Menus and Keypad
Auto Answer Setup
Purpose:
To configure settings for automatic fax reception.
Values:
Junk Fax Filter
Purpose:
To reject unwanted faxes by accepting faxes only from the fax numbers registered in the Fax Address Book.
Values:
Secure Receive
NOTE:
• Secure Receive feature is available only when Panel Lock Set is set to Enable.
Purpose:
To specify whether to require a passcode to receive faxes, and to set or change the passcode.
Values:
*1 This item is available only when Secure Receive Set is set to Enable.
Forward Settings
Purpose:
To set whether to forward incoming faxes to a specified destination.
Values:
Auto Answer Fax 0
*
Sets the interval at which the printer goes into the fax receive
mode after receiving an incoming call. The value is set in
increments of 1 second.
0-255
Auto Answer TEL/FAX 6
*
Sets the interval at which the printer goes into the fax receive
mode after the external telephone receives an incoming call.
The value is set in increments of 1 second.
0-255
Auto Answer Ans/FAX 21
*
Sets the interval at which the printer goes into the fax receive
mode after the external answering machine receives an
incoming call. The value is set in increments of 1 second.
0-255
Off
*
Does not reject faxes sent from unwanted numbers.
On Rejects faxes sent from unwanted numbers.
Secure Receive Set Disable
*
Does not require a passcode to receive faxes.
Enable Requires a passcode to receive faxes.
Change Passcode
*1
0000–9999 Sets or changes the passcode required to receive faxes.
Off
*
Does not forward incoming faxes.
Forward Forwards incoming faxes to a specified destination. Prints
incoming faxes if an error occurs during the transfer.
Print and Forward Prints incoming faxes and also forwards them to a specified
destination.
Forwarding
Number
Specifies the fax number of the destination to which incoming
faxes will be forwarded.
To Next Page
Loading...
Need help?
General
