5.9.2 Prepare and perform a run
Introduction
This section describes how to start a run using a previously created method and how to perform a
manual run. For further information about the capabilities of the System Control module, refer to
UNICORN System Control Manual.
Choose and start a method
The following instruction describes how to open a method and start a run.
ActionStep
Open the System Control module and click the icon Open Method Navigator.1
Result: The Method Navigator pane opens.
Select the method to run, and click the Run icon.2
Result: The Start Protocol dialog opens.
Step through the displayed pages in the Start Protocol, add requested input and make
appropriate changes if necessary. Click Next.
3
Click Start on the last page of the Start Protocol.4
Result:
•
If column logging was chosen during installation of UNICORN and a column type was
selected when the method was created, the Select Columns dialog opens. For further
information on column handling, please refer to UNICORN Method Manual and
UNICORN System Control Manual.
•
If column logging was not chosen during installation of UNICORN and/or no column
type was selected when the method was created, the run starts directly.
ÄKTA pure User Manual 29119969 AB 217
5 Operation
5.9 Create a method and perform a run
5.9.2 Prepare and perform a run
To Next Page
Loading...
Need help?
General
