GE AKTApure User Manual

4.2 Configure modules
In this section
This section describes the software configuration that must be set for the individual modules that are
to be used for a specific run.
A general description of how to update the system properties are found in Edit system properties, on
page 128.
A general decription of how to edit system settings are found in Edit system settings, on page 130.
See pageSection
1324.2.1 Configuration of inlet valves
1334.2.2 Configuration of Mixer valves
1344.2.3 Configuration of Loop valves
1354.2.4 Configuration of column valves
1374.2.5 Configuration of Versatile valves
1384.2.6 Configuration of pH valves
1394.2.7 Configuration of outlet valves
1404.2.8 Configuration of UV monitors
1414.2.9 Configuration of Conductivity monitor
1424.2.10 Configuration of external air sensors
1434.2.11 Configuration of fraction collectors
1454.2.12 Configuration of I/O-box
ÄKTA pure User Manual 29119969 AB 131
4 System configuration
4.2 Configure modules

GE AKTApure Specifications

General

Brand	GE
Model	AKTApure
Category	Laboratory Equipment
Language	English