Detect Memory Card Status
The device detects the status of Hikvision memory card. You receive when your
memory card is detected abnormal.
Before You Start
The page only appears when a Hikvision memory card is installed to the device.
Steps
1.
Go to → Storage → Storage Management → Memory Card .
2.
Click Status to check the Remaining Lifespan and Health Status of your memory card.
Remaining Lifespan
It shows the percentage of the remaining lifespan. The lifespan of a memory card may be
by factors such as its capacity and the bitrate. You need to change the memory
card if the remaining lifespan is not enough.
Health Status
It shows the of your memory card. There are three status good, bad,
and damaged. You will receive a if the health status is anything other than good
when the Arming Schedule and Linkage Method are set.
Note
It is recommended that you change the memory card when the health status is not "good".
3.
Click R/W Lock to set the permission of reading and to the memory card.
-
Add a Lock
a. Select the Lock Switch as ON.
b. Enter the password.
c. Click Save
-
Unlock
●
If you use the memory card on the device that locks it, unlocking will be done
and no unlocking procedures are required on the part of users.
●
If you use the memory card (with a lock) on a device, you can go to HDD
Management to unlock the memory card manually. Select the memory card, and click
Unlock. Enter the correct password to unlock it.
-
Remove the Lock
a. Select the Lock Switch as OFF.
b. Enter the password in Password .
c. Click Save.
Network Camera User Manual
23
To Next Page
Loading...
Need help?
General
