= 100 – S1/ST*100
S1 stands for the target body part that leaves the region. ST stands
for the complete target body.
Example: If you set the value as 60, a target is possible to be counted as a
removed object only when 40 percent body part of the target leaves the region.
Threshold The threshold for the of the objects removed from the region. If you set the
value as 10, alarm is triggered the object disappears from the region for
10s.
5.
Repeat the above steps to set more regions.
6.
For the arming schedule see
Set Arming Schedule . For the linkage method see
Linkage Method .
7.
Click Save.
Note
The is only supported by certain models. The actual display varies with the models.
6.2.9 Set Baggage
It is used to detect the objects over in the region. Linkage methods can be
triggered the object is and stays in the region for a set period.
Steps
1.
Go to → Event → Smart Event → Baggage .
2.
Check Enable.
3.
Select one Region. For the region refer to
Draw Area .
4.
Set rules.
stands for the percentage of the body part of an acceptable target
that enters the region. = 100 - S1/ST × 100. S1 stands for
the target body part that goes across the region. ST stands for the
complete target body. The higher the value of is, the more easily the
alarm can be triggered.
Threshold It stands for the of the objects in the region. Alarm is triggered the
object is and stays in the region for the set period.
Network Camera User Manual
39
To Next Page
Loading...
Need help?
General
