Input IPv6 Address, IPv6 Subnet, IPv6 Default Gateway. Consult the network administrator for
required
MTU
It stands for maximum transmission unit. It is the size of the largest protocol data unit that can
be communicated in a single network layer
The valid value range of MTU is 1280 to 1500.
DNS
It stands for domain name server. It is required if you need to visit the device with domain
name. And it is also required for some (e.g., sending email). Set Preferred DNS
Server and Alternate DNS server properly if needed.
Dynamic Domain Name
Check Enable Dynamic Domain Name and input Register Domain Name. The device is
registered under the register domain name for easier management within the local area
network.
Note
DHCP should be enabled for the dynamic domain name to take
7.1.1 Discovery
Check the Enable Discovery, and then the online network camera can be
detected by client via private protocol in the LAN.
7.2 SNMP
You can set the SNMP (Simple Network Management Protocol) to get device in
network management.
Before You Start
Before the SNMP, you should download the SNMP and manage to receive the
device via SNMP port.
Steps
1.
Go to → Network → Advanced → SNMP .
2.
Check Enable SNMPv1, Enable SNMP v2c or Enable SNMPv3.
Note
The SNMP version you select should be the same as that of the SNMP
Network Camera User Manual
43
To Next Page
Loading...
Need help?
General
