Refer to Set FTP to set the FTP server.
Refer to Set NAS for NAS
Refer to Set New or Unencrypted Memory Card for memory card storage
8.2.3 Send Email
Check Send Email, and the device sends an email to the designated addresses with alarm
when an alarm event is detected.
For email refer to Set Email .
Set Email
When the email is and Send Email is enabled as a linkage method, the device sends an
email to all designated receivers if an alarm event is detected.
Before You Start
Set the DNS server before using the Email Go to → Network → Basic
→ TCP/IP for DNS
Steps
1.
Go to email page: → Network → Advanced → Email .
2.
Set email parameters.
1) Input the sender's email including the Sender's Address, SMTP Server, and
SMTP Port.
2) If your email server requires check and input your
user name and password to log in to the server.
3) Set the E-mail .
●
When you select SSL or TLS, and disable STARTTLS, emails are sent encrypted by SSL or
TLS. The SMTP port should be set as 465.
●
When you select SSL or TLS and Enable STARTTLS, emails are sent encrypted by
STARTTLS, and the SMTP port should be set as 25.
Note
If you want to use STARTTLS, make sure that the protocol is supported by your email server.
If you check the Enable STARTTLS while the protocol is not supported by your email sever,
your email is sent with no
4) If you want to receive with alarm pictures, check Image. The
email has 3 alarm pictures about the event with image
capturing interval.
5) Input the receiver's including the receiver's name and address.
6) Click Test to see if the is well
3.
Click Save.
Network Camera User Manual
55
To Next Page
Loading...
Need help?
General
