HIKVISION DS-K1T341AMF User Manual

Mark as Visitor
If the person is a visitor, you should set the her/his valid mes for visit.
Note
The valid mes for visit is between 1 and 100. You can also check No Limit, then ther
e are no
limited mes for the visitor to access doors/oors.
Device Operator
F
or person with device operator role, he/she is authorized to operate on the access control
devices.
Note
The Super User, Extended Door Open Time, Add to Blocklist, and Mark as Visitor funcons
cannot be enabled concurrently. For example, if one person is set as super user, you cannot
enable e
xtended door open me for her/him, add her/him to the blocklist, or set her/him as
visitor.
6. Conrm to add the person.
-
Click Add t
o add the person and close the Add Person window.
-
Click Add and New to add the person and connue to add other persons.
9.4.10 Customize Person Informaon
You can customize the person properes which are not pre-dened in the client according to actual
needs, e.
g., place of birth. Aer customizing, when add a person, you can enter the custom
informaon to make the person informaon complete.
Steps
1. Enter Person module.
2. Set the elds of custom informaon.
1) Click Cus
tom Property.
2) Click Add to add a new property.
3) Enter the property name.
4) Click OK.
3. Set the custom informaon when adding a person.
1)
Select an organizaon in the organizaon list to add the person and click Add.
Note
Enter the person's basic informaon rst. For details about conguring person's basic
informaon, refer to Congure Basic Informaon .
2) In the Cus
tom Informaon panel, enter the person informaon.
3) Click Add to add the person and close the Add Person window, or click Add and New to add
the person and connue to add other persons.
DS-K1T341A Series Face Recognion Terminal User Manual
108

HIKVISION DS-K1T341AMF Specifications

General

Brand	HIKVISION
Model	DS-K1T341AMF
Category	Touch terminals
Language	English