To Next Page

To Previous Page

6. Click the Card No. column and enter the card number.

Place the card on the card enrollment staon.

wipe the card on the card reader.

Manually enter the card number and press the Enter key.

The person(s) in the list will be issued with card(s).

9.4.22 Report Card Loss

If the person lost his/her card, you can report the card loss so that the card's related access

authorizaon will be inacve.

Steps

1. En

ter Person module.

2. Select the person you want to report card loss for and click Edit to open the Edit Person

window.

3. In the Credenal → Card panel, click on the added card to set this card as lost card.

Aer reporng card loss, the access authorizaon of this card will be invalid and inacve. Other

person who gets this card cannot access the doors by swiping this lost card.

4. Oponal: If the lost card is found, you can click to cancel the loss.

Aer cancelling card loss, the access authorizaon of the person will be valid and acve.

5. If the los

t card is added in one access group and the access group is applied to the device

already, aer reporng card loss or cancelling card loss, a window will pop up to nofy you to

apply the changes to the device. Aer applying to device, these changes can take eect on the

device.

9.4.23 Set Card Issuing Parameters

The client provides two modes for reading a card's number: via card enrollment staon or via the

ard reader of the access control device. If a card enrollment staon is available, connect it to the

PC running the client by USB interface or COM, and place the card on the card enrollment to read

the card number. If not, you can also swipe the card on the card reader of the added access control

device to get the card number. As a result, before issuing a card to one person, you need to set the

card issuing parameters including the issuing mode and related parameters.

When adding a card to one person, click Sengs to open the Card Issuing Sengs window.

Local Mode: Issue Card by Card Enrollment Staon

Connect a card enrollment staon to the PC running the client. You can place the card on the card

enr

ollment staon to get the card number.

Card Enrollment Staon

Select the model of the connected card enrollment staon

DS-K1T341A Series Face

Recognion Terminal User Manual

114

HIKVISION DS-K1T341AMF User Manual

Questions and Answers: