HIKVISION DS-K1T341AMF User Manual

4. Add the device to the client soware.
Note
For details about adding device, see Add De
vice.
5. Call the clien
t soware.
1) Tap
on the device inial page.
2)
Enter 0 in the pop-up window.
3) Tap
to call the client soware.
6. T
ap Answer on the pop-up page of the client soware and you can start two-way audio
between the device and the client soware.
Note
If the device is added to mulple client sowares and when the device is calling the client
soware, only the rst client soware added the device will pop up the call receiving window.
7.11.2 Call Center from Device
Steps
1. Ge
t the client soware from the supplied disk or the ocial website, and install the soware
according to the prompts.
2. Run the clien
t soware and the control panel of the soware pops up.
3. Click Device Management to enter the Device Management interface.
4. Add the main staon and the device to the client soware.
Note
For details about adding device, see Add De
vice.
5. Se
t the main staon's IP address and SIP address in the remote conguraon page.
Note
For details about the operaon, see the user manual of the main staon.
6. Call the cen
ter.
-
If you have congured to call center in the Basic Sengs , you can tap
to call the center.
-
If y
ou have not congured to call center in the Basic Sengs , you should tap
→ t
o call
the center
7. Answers the call via the main staon and starts two-way audio.
Note
The device will call the main staon in priority.
DS-K1T341A Series Face Recognion Terminal User Manual
55

HIKVISION DS-K1T341AMF Specifications

General

Brand	HIKVISION
Model	DS-K1T341AMF
Category	Touch terminals
Language	English