Network Video Recorder User Manual
79
etc., can be detected.
Steps
1. Go to Smart Analysis → Smart Event Settings → Other Events.
2. Select a camera.
3. Click PIR Alarm.
Figure 6-12 PIR Alarm
4. Check PIR Alarm.
5. Optional: Check Save VCA Picture to save the captured of PIR alarm pictures.
6. Set the arming schedule. Refer to Configure Arming Schedule.
7. Set the linkage actions. Refer to Configure Linkage Actions.
8. Click Apply.
6.2.13 Thermal Camera Detection
The NVR supports the event detection modes of the thermal network cameras: fire and smoke
detection, temperature detection, temperature difference detection, etc.
Before You Start
Add the thermal network camera to your device and make sure the camera is activated.
Steps
1. Go to Smart Analysis → Smart Event Settings → Other Events.
2. Select a thermal camera.
To Next Page
Loading...
Need help?
General
